|
11-08-2013, 08:08 PM | #1 | ||
Regular Member
Join Date: Aug 2013
Posts: 36
|
Hi there guys,
just put new bearing hubs on my AU1 wagon, Does anyone know how tight i should tighten the big nut? Many thanks. |
||
11-08-2013, 08:42 PM | #2 | ||
Got Ghia?
Join Date: Jul 2006
Location: Perth
Posts: 999
|
Believe it is the same as au2... somewhere near 300nm will do it.
(manual gives the 305nm figure, also references a range of 260-350nm)
__________________
2007 BF MKII Ghia V8 - BA GT Exhaust| F6 Intake | Superlows | 19" GT-P's | 30mm Swaybar | - Sold 2002 AU2 XR8 Ute - Manual | Leather | Injected LPG | Pacemakers |
||
11-08-2013, 09:15 PM | #3 | ||
Regular Member
Join Date: May 2009
Posts: 241
|
Ft.....
|
||
11-08-2013, 09:20 PM | #4 | |||
FF.Com.Au Hardcore
Join Date: Jan 2006
Posts: 957
|
Quote:
If you don't have a torque wrench that will measure up to the above figure, you can count the number of threads the nut on your other wheels is on from the end of the shaft. Then apply that number to the wheel you want to tighten. It should be close to factory spec. |
|||