Need a quick response - Air Temp Sensor Help

Norton · 20-05-2007, 11:27 PM

Hi Guy's,

I need a quick answer on the best way to install the Air Temp Sensor for my Supercharger install.

If you can help let me know.

I've posted in another area but I thought there may be some AU folks who can help.

http://www.fordforums.com.au/showthr...14#post1484114

Cheers

JC · 21-05-2007, 12:14 AM

In the intake, same as normal. I cant see hwy it would be any different.

Norton · 21-05-2007, 12:22 AM

Quote:

Originally Posted by JC

In the intake, same as normal. I cant see hwy it would be any different.

Just concerned about the added pressure (Under Boost). Don't want it to pop out.

JC · 21-05-2007, 12:27 AM

Quote:

Originally Posted by Norton

Just concerned about the added pressure (Under Boost). Don't want it to pop out.

I did think of that, but it's got a small barb on it, so should be enough to hold it tightly i the factory position. I've also realised you are metal piping - you need to drill a hole large enough to accept the barb, then use a rubber grommet in the hole to keep the sensor from popping.

Or maybe just fit it into the silicon joiner, that should be easy enough to drill a hole slightly smaller than the sensor probe, and supple enough to accept it, yet not spit it back out under boost conditions.